Learn Onshape Fast

Bring your ideas to life with a complete curriculum including easy to follow videos, PDFs, and challenges. Online, on your own time.

The Project-Based Learning is phenomenal and is one of the best getting-started courses out there. Highly Recommended.

Work through the book & videos. Your free e-book comes with this course!

Enroll in Course

Next Class Starts

CAD Class runs on demand. Sign up now and receive immediate access to all training materials.
Time

Each lesson takes approximately 10 - 20 minutes. The entire course takes about 16 hours to complete.
This Class is For

Beginners. If you're looking to level up your Onshape CAD Skills, this is the place to start.
Project Based

You will make CAD models from scratch. In addition to videos, each project has a PDF so you can easily follow along.
Community

Access a private community where you can ask questions about specific projects and get help from your peers and teachers.
Support

Call, email, join the private discussion forum, and get the help you need fast. (415) 941-4114. [email protected]

Course curriculum

1. Course Introduction
  FREE PREVIEW
2. Download Onshape Fundamentals Course Book
  FREE PREVIEW
1. Project: Brick Ring
2. Reinforce & Stretch: Brick Ring
3. Tool Review: Extrude & Fillet
4. True or False Quiz: Brick Ring
5. Review: Brick Ring
6. Challenge: Custom Keycap
1. Project: Emoji Face
2. Reinforce & Stretch: Emoji Face
3. Tool Review: Constraints
4. True or False Quiz: Emoji Face
5. Review: Emoji Face
6. Challenge: Robot Emoji
1. Project: Saturn V Rocket
2. Reinforce & Stretch: Saturn V Rocket
3. Tool Review: Patterning
4. True or False Quiz: Emoji Face
5. Review: Emoji Face
6. Challenge: Involute Gear
1. Design Intent & Review
1. Project: Carabiner
2. Reinforce & Stretch: Carabiner
3. Tool Review: Sweep
4. True or False Quiz: Carabiner
5. Review: Carabiner
6. Challenge: Hex Key Set
1. Project: Finger Surfboard
2. Reinforce & Stretch: Finger Surfboard
3. Tool Review: Lofting
4. True or False Quiz: Finger Surfboard
5. Review: Finger Surfboard
6. Challenge: Claw Hammer
1. Project: Pizza Cutter
2. Reinforce & Stretch: Pizza Cutter
3. Tool Review: Assemblies & Mates
4. True or False Quiz: Pizza Cutter
5. Review: Pizza Cutter
6. Challenge: Pizza Party
1. After Fundamentals (Collaboration, Versioning, Onshape Mobile, FeatureScripts, App Store, Sheet Metal, Surface Modeling, Engineering Drawings)
2. True or False?
3. End of Course Test Pt.1
4. End of Course Test Pt.2
1. Conclusion and Next Steps
2. Additional Resources
3. CADclass Resources